EPARMS RotoClip - ZFH short
The EPARMS RotoClip was specially developed for combined and common hunting rifles, it is the only adapter on the market that guarantees a repeat accuracy of +/- 0.1 mm!
The system, for which a worldwide patent has been applied for, is characterized by many features such as fine centering when inserting the thread insert, the interrupted round thread and the half-shell tension on the objective of the riflescope.
Due to the very small range of 15 mm (short) - 25 mm (long), it is also possible to equip combined weapons with attachments, something that no manufacturer on the market has yet succeeded in doing.
Another major advantage is that it can be used multiple times on different rifle scopes without having to shoot in again! (Initial setting required)
For example, you have a riflescope with an outer diameter of 62 mm and another with 56 mm, here you only need another adapter in the corresponding size of your riflescope and you can swap your device without removing your adapter on the device.
Installation and commissioning instructions:
The adapter is firmly attached to the objective of the rifle scope with 4 - 6 screws M3 with a tightening force of 3-5 Nm, the adapter must be aligned before use, this is done as before via the auxiliary cross of the attachment (thermal image), with night vision devices pay attention to what the manufacturer of the device specifies (alignment of the switch, e.g. 12 o'clock).
Once you have made the alignment, you can start the test shooting and correct the alignment of the adapter if necessary.
If you are satisfied with the result, you can now proceed in the same way on your second rifle scope.
Attention !!!! Please do not correct your thermal imaging camera again, but align your adapter so that the auxiliary cruiser matches your reticle as with your first rifle scope.
Shoot again and you will find that there are no significant deviations.
- Small clamping range of 15 - 25 mm required
- Can be used for combined weapons
- is firmly attached to the eyepiece of the riflescope using 4-6 M3 screws
- 100% reproducible point of impact
- The attachment can be used on multiple riflescopes
- Very short design for short runs with a silencer
- 100% Made in Germany
- Black anodized aluminum
- the unit of measurement ZFH ... mm always refers to the outer diameter of the riflescope